Boss 1911 Single Stack Complete Rig

5 x Double Alpha Racer Mag pouches 

• Includes bullet nose out (Ben Style) and bullet nose forward (conventional) pouches
• Works with Single Stack 1911 Mags
• Available Colors : Black, Red, Blue, Grey

1 x Double Alpha (DAA) Premium Belt

• Available Colors : Black, Red, Blue, Silver

1 x BSPS BOSS DOH Holster

• includes thumb screws

We recommend measuring the spacing of the gun to the belt to ensure it falls within the rules of the sport and division.

We have found the standard spacers (1/2") will fall within the spacing rules so long as you are using the standard belt mount. If you want to use the Comp-Tac PLM or the Blade-Tech Tek-Lok you should select the short spacers (1/4").

IMPORTANT: How to select the correct belt size:

Option 1:
If you do not wish to measure your waist, and choose to go off your US Jeans size, then order a belt two sizes larger than your Jeans size tag.
So if your US Jeans state size 36 waist, order our belt in size 40.

Option 2 (recommended!):
1. Measure you actual waist circumference at the height where you plan to wear your belt.
2. Convert your measurements into Inches (1inch = 2.54cm)
3. Order the belt size which matches your measurement. Round upwards: if you measured 39”, order a belt size 40”.

NOTE: All belt systems include both inner and outer belts, as well as a rubberized Security loop.

Buyers may exchange the belt for a different sizes but the buyer is responsible for shipping both ways.

Which Offset length should I choose?

This refers to the length of the spacers between the long Boss plate and the Y-Plate that attaches to the holster. The 1/2" spacers are a pretty safe bet for most firearms out there to keep you within the rules for USPSA. 

If you go with one of the options mounts (Tek-Lok, PLM, ELS) we would recommend choosing the 1/4" spacers to keep your holster within the rules for USPSA.

We have seen the 1/2" work well for most models

We have found the 3/4" spacers to work with most models but you should measure your setup to insure it falls within the USPSA rules.

You can always just buy the Spacer Hardware Kit here and try the other options. 

What is the optional Baller Ball Joint?

Upgrade your Boss Holster Hanger with the new release from Shockbottle, the Boss Baller Ball Joint.

This ball joint upgrade for your Boss Hanger allows you to adjust the angle of the holster and still raise and lower it as you expect with the Boss Holster Hanger.

You can use the ball joint instead of the spacers on your current rig!

What is the optional Aluminum Thigh Pad?

Comfort and Adjustability Boss Holster Hanger Aluminum Thigh Pad features a unique design that allows you to adjust the spacing of your Boss holster hanger to your personal preference, providing maximum comfort and flexibility.