Boss Holster Hanger Installation Instructions

 

How to Install

 

1. Attach Y-plate to holster body through three large holes on the Y-plate using supplied short round-head screws to the backers included with your holster.

2. Attach Y-plate to slotted hanger plate using supplied long screws and spacers (do not install lock washers yet). Screw heads should be on the rounded side of the hanger plate, one screw in a center hole and the other in the corresponding curved slot.

3. Hold belt inside belt plate cutout and install onto main hangar plate with 4 flat-head screws, solidly mounting holster and hanger to belt.

4. Test location of holster with unloaded firearm. Adjust to preferred height and tilt by changing screw positions on the main hangar plate and Y-plate. Verify position meets rule requirements

5. Mark position of long screws lightly with a pencil and then remove and re-install the long screws with a lock washer underneath the screw heads. Apply threadlocker to all screws.  

* Verify firearm position meets appropriate rule requirements