CZC Extended Firing Pin "Non Firing Pin Block Models CZ 85C, TS, TSO, Czech Mate, Shadow, Shadow 2, A01 by CZ Custom
New Extended Firing Pin for better ignition.
For CZ guns with Firing pin plate retention NOT Cross pin.
Use in combination with CZ 2075 Factory Firing Pin Spring.
For even better results on hard primers.
Fits
CZ 85 Combat
SP01 Shadow
Shadow 2
CZ75 Shadow
Tactical Sports (TS)
Czech Mate
1 Review
-
A bit too long for peace of mind
I ended up sanding down the hammer-end of the pin enough so that it is just barely more exposed to the hammer than the factory pin. This was because that at its shipped length, it protrudes quite a bit from the firing pin hold where the round primer sits. This would almost certainly result in a drop fire if the weapon landed on the hammer. Once you sand it down, it no longer protrudes, but is still longer than the factory pin which is what I wanted. I generally followed the guidance in this post from 2011 https://forums.brianenos.com/topic/139857-extended-firing-pin-fitting/ Only rating 4/5 because of the 30 minutes I had to spend to fit it to the gun.
