Glock Trijicon RMR Red Dot Optic Sight Mount by EGW (49513)
Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw
Red Dot Fitment: Trijicon RMR, Holosun HS507C, HS407C, HS508C
The mounting screws require a 5/64" wrench and the set screws (when applicable) require a 1/16" wrench.
This mount fits all generation Glocks:
Tactical Solutions .22lr Conversion
Advantage Arms .22lr Conversion
Does not fit Glock MOS models.
Glock 17 Gen 4 MOS
Glock 19 Gen 4 MOS
Glock 34 Gen 4 MOS
Glock 40 Gen 4 MOS
Glock 41 Gen 4 MOS
Glock 35 Gen 4 MOS
Glock 34 Gen 5 MOS
Our Glock sights are meant to be installed from the left to the right. The dovetail has a progressive taper to allow for easier install.
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs
2 Flat Head Cap Screws - Provided for Trijicon RMR
The screws that are included with this mount require a 5/64'' allen wrench for installation.
Click here to see a video from Vortex on how to install our red dot base on a slide.
High quality product with one piece design. Fit as advertised.