Magazine Base Pads 4-Pack fits Glock by 10-8 Performance

These base pads are injection molded from glass reinforced nylon, and they are super tough and resistant to impact.  Our pads fit and install the same as the factory floor plates, use the factory retainer plate (magazine insert), and no extra parts are required. 

The 10-8 pad is slightly thicker than the factory pad, and features angled sides and front to allow for easy stripping of stuck magazines.  The pads also feature a grooved front and scalloped sides for positive grip during manipulations.  The bottom of the pad features our usual dimples for marking your magazines.

Fits Glock factory magazines for 9mm, .40 S&W, .357 Sig, .45 GAP.  NOT compatible with early production non metal lined (Gen1) Glock magazines, but do fit all subsequent generations to include those for the Gen5. NOT COMPATIBLE with Glock 26/27 where the magazine base pad has to fit in a recess in the frame. **Our pads DO fit in the Gen 5, 17/19M, and 19X. The Glock 19X frame has a lip at the front and our pads will just barely clear. Also fits KCI and ETS Glock magazines. DOES NOT fit Magpul Glock magazines.

Compatible with many magazine wells, including the Raven Concealment Systems Freya, Magpul, Zev Pro, Battle Arms Development, Killer Innovations, and Overwatch Precision. Is known to be INCOMPATIBLE with the Zev Universal Pro magwell. Please note that with certain mag wells (including Magpul and Zev Pro), individual frame/magazine combos may exhibit tolerance stacking and our base pad may interfere with the ability of the mag to lock into place when loaded.

Coyote and Olive Drab pads are limited production runs and may be priced differently. The colors were matched to new production Glock Gen4/5 frames, but Glock production runs vary in hue, so we can't guarantee an exact match to your particular frame. **We changed the name of our "Glock Dark Earth" pads as our color seems to match the Glock 19X Coyote better.**

Weight: .24 oz.

**SOLD AS A SET OF FOUR (4)**

**NOTE: We do not recommend excessive disassembly/reassembly of Glock magazines, as the retainer tabs molded on the bottom of the magazine tube are relatively soft and will ding up with each time the pad comes off or goes on the tube.  This happens with both Glock factory pads as well as ours.  We do not find that Glock magazines get a lot of dirt inside, so it is typically unnecessary to disassemble them for anything other than spring replacement.

Common questions answered:

• Will you be making this for the .45 ACP/10mm magazines? 
• Not any time soon, due to limited demand.
• Are these easier to remove and install than the factory base pads?
• No, they remove and install exactly the same way.  Keep in mind that "easy to remove" ends up meaning that the magazine will come apart when it hits the ground.

DISCLAIMER: This product is not manufactured, authorized, endorsed,
or warranted by GLOCK. GLOCK does not warrant or represent that
this product is compatible with GLOCK pistols.

DISCLAIMER: “GLOCK” is a federally registered trademark of
GLOCK, Inc. and is one of many trademarks registered by GLOCK, Inc.
and GLOCK Ges.m.b.H. Neither Ben Stoeger Pro Shop nor this site are
affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or
GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to
advertise the sale of pistols, parts, components or accessories that are
compatible with GLOCK. For additional genuine GLOCK, Inc. and
GLOCK Ges.m.b.H. products and parts visit www.glock.com.