Canik Rival S 24 Round Magazine Kit

This magazine kit utilizes a factory Canik 18rd Magazine Tube with an MBX "Ultra Max" Spring & Follower with the Henning Magazine Extention. This combonation of parts will get you 24 rounds in the mag but you will not have slide lock. The magazine will also fit the 140mm mag gauge for USPSA Carry Optics and Limited Optics.

Factory 18rd Canik Magazine Tube
Henning Magazine Extension
MBX "Ultra Max" Spring & Follower
Holds 24+1 Rounds
USPSA Carry Optics & Limited Optics Legal

Henning Base Pad

Our extended base pads are legal for USPSA Limited and Open competitions. Attached to the factory magazines they extend the magazine to 141.25mm length (5.56"). Whether you want to be competitive or not, these pads will extend the capacity of your Canik Rival-S magazines.

Our extensions are EASY to take on and off with our spring-loaded steel detent. It locks the extension onto the magazine tube very tight and securely.

Just adding this magazine extension to the factory Canik Rival-S magazine (with or without magwell),

MBX "Ultra Max" Spring & Follower for Canik TP9 SFX/ Rival / Mete

IMPROVE YOUR EXTENDED 140 FACTORY MAGAZINE PERFORMANCE WITH MBX “NEW” MBX 'ULTRA MAX' SPRING & FOLLOWER SET FOR FACTORY CANIK MAGAZINE

NO SLIDE LOCK FUNCTION

ATTENTION!
Before Inserting Magazine Into Firearm

New MBX competition follower & spring sets need to be loaded 4-6 times to capacity preventing follower popping out when new , insuring spring set and the follower sits down in tube when new, this avoids any slide contact and damange to spring and follower voiding warranty as the competition follower is NOT held down by the slide stop and has minimal surface area , the competition follower is designed once spring is set to sit 1/4-3/8 below top of feed lips thus avoiding damaging slide contact with follower once magazine is empty.