EGW Tanfoglio / EAA / IFG - Trijicon RMR Red Dot Optic Sight Mount  

EAA / Tanfoglio Witness Stock II (2), Stock III (3), Limited Pro, Limited, P Match, P Match Pro

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR, Holosun HS507C, HS407C, HS508C, Trijicon SRO

The mounting screws require a 5/64" wrench and the set screws (when applicable) require a 1/16" wrench.

This mount fits:
EAA / Tanfoglio Witness with adjustable rear sight (windage AND elevation)

This mount does not fit:
EAA / Tanfoglio Witness with fixed rear sight

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Click here to see a video from Vortex on how to install our red dot base on a slide.