Henning

Walther PDP V1 Plus 4 Magazine Extension by Henning

$39.95
No reviews yet Write a Review
SKU:
H140-PDP-V1
Shipping:
Calculated at Checkout

Frequently Bought Together

Please choose options for all selected products

  • Choose Options

Walther PDP Plus 4 Magazine Extension V1 by Henning

Our extended base pads are legal for USPSA Limited and Open competitions. Attached to the factory magazines they extend the magazine to 141.25mm length (5.56"). Whether you want to be competitive or not, these pads will extend the capacity of your Walther PDP magazines. 

Our extensions are EASY to take on and off with our spring-loaded steel detent. It locks the extension onto the magazine tube very tight and securely. 

Just adding this magazine extension to the factory Walther PDP magazine, it will increase the capacity from 18 to 22 rounds, but the factory spring is recommended to be replaced with an aftermarket follower kit.

You can use the MBX aftermarket follower kit to get 23 +1.

DOES NOT WORK WITH THE NEW PDP STEEL MODEL.


MBX "Ultra Max" Spring & Follower

*Note This Product will not lock slide back on last round fired

ATTENTION!
Before Inserting Magazine Into Firearm

New MBX competition follower & spring sets need to be loaded 4-6 times to capacity preventing follower popping out when new , insuring spring set and the follower sits down in tube when new, this avoids any slide contact and damange to spring and follower voiding warranty as the competition follower is NOT held down by the slide stop and has minimal surface area , the competition follower is designed once spring is set to sit 1/4-3/8 below top of feed lips thus avoiding damaging slide contact with follower once magazine is empty.

Our Magazine Parts Policies