UniqueTek Spent Primer Chute for the Dillon 650 Press
The 650 Spent Primer Chute™ replaces the blue plastic spent primer cup and bracket on the Dillon 650 reloading press. Spent primers are routed through clear PVC tubing into any convenient waste container. The 650 Spent Primer Chute™ completely covers the spent primer ejection port, creating a fully enclosed pathway for spent primers ... so they simply can't bounce out!
No more spent primers bouncing out and onto the floor when you reload!
Comes with 3 feet of clear PVC tubing, long enough to route spent primers to a container on, or under, your reloading bench. Route it to a 5-gallon paint pail and you won't need to empty the spent primers for a very long time! You can even drill a 1/2" hole directly under the press, run the PVC tubing through the hole, and place a container under your reloading bench where it is out of the way.
650 Spent Primer Chute™ - Custom molded in strong, durable Black HDPE.
3 Feet of Clear 1/2" PCV Tubing
Remove the Spent Primer Cup and Spent Primer Cup Bracket.
Install the 650 Spent Primer Chute™ using the original screws.
Attach the tubing to the 650 Spent Primer Chute™ and route to any convenient container on, or under, your reloading bench.
NOTE: WILL NOT FIT CERTAIN OLDER XL 650 PRESSES
The 650 Spent Primer Chute™ will not fit certain older XL 650 presses ... manufactured prior to about 1997. These older presses do not have the same mounting bracket for the Spent Primer Cup, so don't have the threaded screw holes needed to mount the 650 Spent Primer Chute™.
WILL NOT FIT: If your press is quipped with Spent Primer Cup Bracket (part #13421) and Spent Primer Cup (part #13420), the 650 Spent Primer Chute™ will not fit.*
WILL FIT: If your press is equipped with the blue Spent Primer Cup (part #16211) and Spent Primer Cup Bracket (part #16209) attached by two screws (part #14689), then the 650 Spent Primer Chute™ will fit.*
* Please refer to the "Platform Assembly Drawing" in your Dillon XL 650 Instruction Manual for these part numbers and their locations on the press.
NOTE: WILL NOT WORK ON THE SL 900 SHOT SHELL PRESS
Although the SL 900 Shot Shell Reloader is based on an XL 650 frame, and the 650 Spent Primer Chute™ will NOT work. 209 shotshell primers are too large to pass through the 650 Spent Primer Chute™ fitting.
Took some tinkering to get the right position. Too expensive for what it is.