Boss Holster Hanger Aluminum Thigh Pad
If you are looking for a high-quality Boss holster hanger accessory that can provide maximum comfort, and functionality, the Boss Holster Hanger Aluminum Thigh Pad is the perfect choice for you. This thigh pad has been designed to provide an optimal fit and comfort for your holster.
The Boss Holster Hanger Aluminum Thigh Pad features a unique design that provides maximum comfort.
Key Features:
- Made from Aluminum with a hard anodized finish
- Slick low friction Thigh Pad for maximum comfort
- Compatible with new and older Boss Hangers*
- Easy to install and use
*Older Boss Hanger will require the user to drill a 13/64" hole to accept the included hardware.
Included Materials:
- Thigh pad
- T-nut backer
- Short screw
Instructions:
- Make sure you have a Boss Hanger long plate with a 1/5" hole. If you have an older model without the hole, you can either upgrade to the newer model or carefully drill a 1/5" hole in your hanger. Remember to follow all safety precautions and measures when drilling.
- Place the T-nut backer in the 1/5" hole in your long plate.
- If you are using the optional spacer, place it between the thigh pad and the Boss Hanger. In this case, you will need to use the longer screw for installation.
- If you are not using the optional spacer, proceed with the shorter screw.
- Before installation, apply a drop of blue Loctite to the tip of the screw to ensure it remains secure and does not loosen over time.
- Align the holes of the thigh pad (and spacer, if using) with the T-nut backer on the Boss Hanger. Insert the appropriate screw (long or short) through the thigh pad, optional spacer, and into the T-nut backer.
- Tighten the screw firmly by hand until secure. Do not over-tighten, as this may damage the components.
- Once the screw is tightened, your thigh pad is in place and ready for use.
Please make sure to periodically check the tightness of the screw and reapply Loctite if necessary. Enjoy your new Boss Hanger Thigh Pad!
2 Reviews
-
Holster Thigh Pad
Works as advertised however it negates the ability to use the last drop slot on the hangar forcing you to mount the firearm higher. A small cut out might fix the issue.
-
Holster hanger pad
This spacer/pad is made very well. Does what it should. It’s aluminum but it doesn’t need to be. Could be lighter and still do the same if it was made out of the same plastic that the washer/spacer was made out of. It would be lighter so I would like it better and it would give you a better profit margin. Win win. ?