DAA Mr. BulletFeeder Bullet Feed Die Assembly Only by Double Alpha Academy
The Mr.BulletFeeder die assembly is the “clever” part of the Dropper, the part that allows only one bullet to drop while retaining the rest of the stack.
Made of Anodized Aluminum, this assembly is caliber specific and includes a threaded die body, an inner aluminum dropper tube, a nut, clip and 3 steel balls.
This assembly is the same item used for both the Mr.Bulletfeeder and the Mini Mr.Bulletfeeder by DAA.
These Die assemblies are sold separately, to enable you to set up a 2nd tool head, leaving the die correctly adjusted on each. If similar calibers are in use, such as 9mm on one toolhead and 38 on a 2nd, you can transfer the upper part of the dropper from one to the other, leaving only the die on the dedicated tool head, permanently adjusted. This will save you buying a complete new dropper for the 2nd caliber, and also mitigate the need to detach the wiring and the feed spring from the top of the dropper assembly as you switch over calibers..
2 minutes before I was cranking out rounds.
I've tried bullet feeders from Lee, RCBS and Hornady. They were terrible, too finicky or too unreliable. Once I saw the construction and understood the function of this feeder I knew I finally found something that would work. Literally took about 2 minutes to get this feeder setup and running. Love it! I got the 9mm/38 feeder. Thinking of getting a 223 as well. Great product!
When I am loading, I want dependable bullet drops and this product DELIVERS. Nice tolerances and anodized finish coupled with a simple concept, design and setup makes this a surefire staple on all of my presses. A+
using on Dillon 650.....
Works great on newly acquired Dillon 650... Not I have to but the complete bullet feeder system but loading 5 in the collar is pretty fast....
EASY TO SET UP WORKED OUT OF THE PACKAGE NO FUSS AM GOING TO BUY A SECOND ONE
INSTALLED IT WITH NO PROBLEM , RAN THE SYSTEM IN MINUTES NO FUSS OR FANCY PROCEDURES JUST GOES ...
Great product, a must have!
I've been looking hard for a bullet feeder for reloading .223 Rem and I found this and I'm very impressed with it. I look forward too reloading faster and better than before when I had to use my cramping fingers.
You made an amazing product this thing works great .Thanks for this product
Ordered this because it would reliably function with cast as well as jacketed and moly coated bullets. Works reliably and setup is quick and easy! VERY pleased!